Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-ADC

From GNUBLIN

Adc-einzelteile.jpeg

Before the GNUBLIN ADC modules can be put into operation, even smaller, easy soldering must be performed before. Advance should be checked that all components have been included.

  • PCB populated with SMD
  • 1 x socket (Gnublin connector)
  • 5 x 2-pin header
  • 2x 3-pin header
  • 3x 3-way screw terminals
  • 7x jumper

Assembly

Gnublin adc2.jpeg

When soldering the components, it is important that you start with the flattest part. This results in the following soldering order:

  1. All pin header
  2. Jack (Gnublin connector)
  3. screw terminals

For the screw terminals, it is important that the openings facing outward. At installation, it can refer to the above description.

In other languages