Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-Extension

From GNUBLIN

EXTENSION mit Bauteilen.JPG

Please check, either with the photo above or on the following list, if all components are present:

  • 1 x Board
  • 1 x display
  • 1 x Coin-cell battery holder
  • 1 x Coin-cell battery
  • 1 x Wannenbuchse (2x7 polig)
  • 3 x Jumper
  • 1 x Buzzer
  • 1 x quartz for RTC
  • 3 x 3-pin header for addresses
  • 3 x 3-pin header
  • 2 x 2-pin header
  • 1 x 14-pin connector
  • 5 x jumper

assembly

First the pin-headers should be soldered, followed by the quartz. The 14-pin connecter has a small opening at one side. This opening must point away from the board. The display can be soldered directly to the board. Then solder the buzzer and the battery holder.

MODULE-EXTENSION schraeg.JPG

In other languages