Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-LAN

From GNUBLIN

MODUL LAN einzeln.jpg


Two minor soldering work is needed before you can take the Module-LAN in operation. But first, please check all components are included.

  • MODULE-LAN board (nents with SMD preassembled)
  • RJ45 socket
  • Socket Connector for Gnublin
  • Note: Behind the RJ45 jack no part is missing. There is an optional mounting space for a different form factor of the crystal.

Assembly

The figure below describes the module and its main components.

350pxg

It is best to begin with soldering the jack (Gnublin connector) and then with the RJ45 socket.

Startup

Connect the module to the Gnublin on the ribbon cable, then you can go ahead with the following article.

Network with MODULE-LAN

In other languages