Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-Portexpander

From GNUBLIN

MODULE-PORTEXPANDER mit Zubehör.JPG

Introduction

Before starting the GNUBLIN Module-portexpander there are a few small solderings to be made. However, you should first verify that all components have been included. Equipped

  • 1 x board with SMD
  • 1 x socket for Gnublin Connector
  • 2 x 10 pin headers
  • 2 x 2 pin header
  • 3 x 3 pin header
  • 5 x jumper

Assembly

When assembling the components, it is cleverly when you first start with the pin header and the two headers. Subsequently, the terminal can be soldered. The figure below describes the module to the parts and service to help you in the placement of the components.

MODULE_RELAY beschreibung

Now you module is fully assembled and can be connected to the Gnublin via the ribbon cable.

In other languages