Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-RTC

From GNUBLIN

MODULE-RTC mit Zubehör.JPG

Before the GNUBLIN Module-RTC can be put into operation, smaller, easy soldering must be done before that. Before should be verified that all components have been included.

  • 1 x PCB (with SMD components preassembled)
  • 1 x socket for Gnublin Connector
  • 2 x 2 pin header
  • 1 x Battery Holder
  • 1 x battery (2032)
  • 2 x jumpers
  • 1 x 32.768 kHz crystal


Assembly

It is best to start with soldering the crystal, then you do with the pin-headers and the socket on. In the end, assemble and solder the battery holder. The following figure describes the main components of this image you can be guided by the assembly.


MODULE-RTC SCHRAEGBILD 002.jpg

Now connect the module to the Gnublin via a ribbon cable.


Startup

If the MODULE RTC be the only one on the Gnublin connector, then have the I2C pull-up resistors will be populated. In addition, the I2C address pins must be set as shown in following figure.

In other languages