Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-Rail-DAC

From GNUBLIN

Gnublin-module-dac-aufbauanleitung.jpg

Introduction

Before you commissioning the GNUBLIN Module-Rail-Relay you have to do some small soldering. First check, if all parts are correctly delivered.

  • Assembled and soldered PCB (SMD)
  • 6 x 2 pin terminals (green)
  • 2 x 14-pin sockets

Assembly

Now solder the parts in the following order: Frist the 14-pin sockets. Then solder the pin terminals. you can connect two of them before you solder them. See the following picture:

Schraubklemmen zusammenstecken.png

The figure below describes the module and its components to help you with the placement of the components.

Dac-beschriftet.jpg

Now the module is ready to use.

In other languages