Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-Step

From GNUBLIN

Schritt mit zubehoer.jpg


Before the GNUBLIN Module-Step can be put into operation, smaller, easy soldering must be done before that. Before should be verified that all components have been included.

  • board populated with SMD
  • 1 x capacitor
  • 1 x socket (Gnublin connector)
  • 3 x 2-pin header
  • 1 x 3-pin header
  • 3 x 2-way screw terminals
  • 3 x jumper


assembly

When soldering the components, it is important that you start with the flattest part. This results in the following soldering order:

  • All pin header
  • Socket (Gnublin connector)
  • Terminals
  • Capacitor

In the terminals, it is important that the openings point away outward from the board so. At installation, it can refer to the above description.

Start

At this point we assume that you only have the only connected this module to the Gnublin connector. So even the I2C pullup resistor jumpers must be inserted. You also have the I2C address pins are bridged via a jumper. How do you put jumper, can be seen from the figure below are taken.

In other languages