Homepage Wiki Forum Buy

Construction manual GNUBLIN Module-Temperature

From GNUBLIN

MODULE-TEMPSENSOR mit Zubehör.JPG


Introduction

Before you can take the MODULE_TEMPERATURE in operation, yet easy soldering must be made. First, you should verify that all components have been included.

  • PCB populated with SMD
  • Socket Connector for Gnublin
  • 3 x 3 pin header
  • 2 x 2 pin header
  • 5 x jumper

Assembly

Solder first the pin header and then the socket on the board.

MODULE_TEMPERATURE Beschreibung


Now you can connect the module with the help of the ribbon cable with the Gnublin. At this point, we assume that only one module through the connector is connected to the Gnublin. Therefore, the pull-up resistors on the module must be set this happens with the two jumpers. In addition, the address pins should be set using the three jumpers.


MODULE_RELAY Beschreibung

In other languages